Studio-electronics ATC-1X Manuel d'utilisateur télécharger pdf (Page 24)

 Maximum voices: one

 Parameter resolution: 16 bit

 Display: 3 digit light emitting diodes

 Sound memory: internal RAM, 512 patches

 Frequency response: very low to dog bothering

 Residual noise level: really quiet

 Total harmonic distortion: not much, but just enough

 External dimensions: 19" x 10" x 31/2" (2 rack spaces)

 Output: -15 dbm

 Power supply: AC 90 - 250 VAC (50/60hz) auto switching

 Weight: 8lbs of expertly designed well wrought genius

 CV out: 0 - 10 volts / Gate out: 10 volt positive V-trigger

No sound:

i. Are the connections correct?

ii. Is the filter cartridge properly inserted?

iii. Is the volume of the ATC-X turned up?

iv. Are the MIDI channel settings correct?

The pitch is wrong:

i. Is the master tuning setting correct?

ii. Are the octave transpose, coarse tuning/fine tuning settings correct?

Accidentally turned the power off while editing:

i. Unsaved patch edits will be lost.

Note is stuck on:

Although the ATC-X has been thoroughly tested for potential software bugs, we cannot

simulate all possible user setups. So in some instances, the ATC-X may "lock up" or "stick"

on a note. To rectify this situation, try one or more of the following fixes: Play and hold more

than 8 notes; send an (all notes off) command from your sequencer; recycle the power.

1 2 ... 19 20 21 22 23 24 25

Pas de commentaire

Studio-electronics ATC-1X Manuel d'utilisateur Page 24